Advantage compared to the PH2.0
★Solve the voltage sag problem
★15A continuous current, 20A burst
★1.0mm gilde banana connector decreased internal resistance

Receiver option:

Internal SPI Frsky version (Compatible with ACCST D8/D16, Recommend D8 mode)

Internal SPI Flysky version(Compatible with AFHDS and AFHDS-2A Flysky transmitter)

External Frsky RXSR receiver version(ACCST D16 sbus output)

External TBS Crossfire Nano receiver version

Flight controller	(Frsky SPI RX version) CRAZYBEEX FR V1.0 FC Firmware target: CrazybeeF4FR (Flysky SPI RX version) CRAZYBEEX FS V1.0 FC Firmware target: CrazybeeF4FS (External Frsky RXSR version) CRAZYBEEX PNP V1.0 Firmware target:CrazybeeF4DX (External TBS CRSF NANO version) CRAZYBEEX PNP V1.0 Firmware target:CrazybeeF4DX MCU:STM32F411CEU6 (100MHZ, 512K FLASH) Sensor: MPU-6000(SPI connection) Board size: 28.5 * 28.5MM Power supply: 1-2S battery input (DC 2.9V-8.7V) Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready Built-in Betaflight OSD(SPI Control) Built-in 5.8G VTX Built-in SPI Frsky/Flysky receiver or no receiver Built-in 5V 1A BEC Built-in voltage detection
Motor	Mode: NX0802 22000KV Configu-ration:9N12P Stator Diamter:8mm Stator Length:2mm Shaft Diameter:Φ1mm Motor Dimension(Dia.Len):Φ10.5mm14.9mm Weight(g): 1.7g No.of Cells(Lipo): 1S only
Onboard 4in1 ESC	MCU upgraded to EFM8BB21 Power supply: 1-2S LiPo/LiPo HV Current: 5A continuous peak 6A (3 seconds) Support BLHeliSuite programmable Factory firmware: S_H_50_REV16_7.HEX Default protocol: DSHOT600
Propellers	Gemfan 1219-3 Center Thickness:5mm Prop Disk Diameter:31mm Center Hole Inner diameter:1.0mm
Onboard 5.8g VTX	Output power: 25mw Frequency: 40CH Input voltage: 3.3V 5.5V Current consumption: 300mA(type) Frequency: 5.8GHz 5bands 40 channels With Race band Smartaudio ready
Caddx ANT Lite Camera	Image Sensor 1/3" CMOS Sensor Horizontal Resolution 1200 TVL TV System NTSC/PAL switchable MENU SUPPORT IMAGE 16:9 Synchronization Internal Electronic Shutter PAL: 1/50~100,000; NTSC: 1/60~100,000 S/N Ratio >52dB (AGC OFF) Video Output CVBS Lens 2.1mm Min. Illumination 0.001Lux@F1.2 Auto Gain Control YES BLC YES WDR Global WDR DNR 2 DNR Dimensions 14mm*14mm Wide Power Input DC 3.7-18V Work Temperature -20℃~+60℃ Work Humidity 20%~80% Weight 1.5g (N.W.)
Lipo Battery	Capacity:250mAh Voltage:3.8v Continuous Discharge Rate: 30C Size: 55mmx12mmx7mm Weight: 6.5g Connector: ET2.0
Multi port Lipo/Lihv battery charger	Weight: 41g Dimensions: 82x51x22mm Input: DC 7V-22V Output switchable: Fixed at 200~600 milliamps Cutoff voltage switchable: 4.20v cell charging cutoff (+- 0.5% margin of error) for 1S Lipo Battery 4.35v cell charging cutoff (+- 0.5% margin of error) for 1S 3.8V LIHV Battery
Onboard Frsky SPI D8 Receiver Version	SPI BUS receiver Frsky D8 compatible Compatible Non EU transmitter D8 model Channels: 8ch Failsafe support No ground interference ( Transmitter and receiver 1 m from the ground): 100m~200m
Onboard Flysky SPI Receiver Version	SPI BUS receiver Protocol: AFHDS and AFHDS-2A Switchable Channels: 8ch(AFHDS) or 14ch(AFHDS-2A) No ground interference ( Transmitter and receiver 1 m from the ground): 100~200m Failsafe support
External Frsky R-XSR receiver version	Number of channels: 16CH (1-16CH from SBUS channel, 1~8CH from CPPM channel) Operating Voltage Range: 3.5V~10V Operating Current:70mA@5V Firmware Upgradable Compatibility: FrSky X Series modules and radios in D16 mode Could support Frsky New ACCESS Protocol ( Upgrade firmware) Weight: 1.5g
External TBS CRSF Nano receiver version	Original TBS CROSSFIRE Receiver ,CRSF Protocol , Official TBS transmitter compatible